Abstract:
Semi-coke is an excellent candidate fuel for direct carbon-solid oxide fuel cell (DC-SOFC), and its gasification reaction rate with CO
2 is the key factor that effects the performance of DC-SOFC fueled semi-coke. In order to improve the gasification reactivity of semi-coke with CO
2, the Ca
2Fe
2O
5 catalyst with perovskite structure has been prepared using citric acid sol-gel method. The morphology and structure of the Ca
2Fe
2O
5 catalyst has been investigated using SEM, XRD, XPS, low-temperature nitrogen adsorption-desorption methods. The catalytic activity of Ca
2Fe
2O
5 catalyst in the gasification reaction of semi-coke with CO
2 has been studied by thermogravimetric measurements. The effect mechanism of the semi-coke fuel added Ca
2Fe
2O
5 catalyst on the output performance of DC-SOFC has been investigated using Ag-GDC|YSZ|GDC-Ag electrolyte supported DC-SOFC. The results indicate that as the calcination temperature of the catalyst increases, the grain size of Ca
2Fe
2O
5 catalyst gradually increases and the specific surface area decreases. The catalyst calcined at 750 ℃ has good dispersibility and a particle size of approximately 0.1 μm exhibits the best catalytic activity in the gasification reaction of semi-coke and CO
2. Compared to the CaO and Fe
2O
3, the Ca
2Fe
2O
5 catalyst structure has a higher concentration of adsorbed oxygen, which is more conducive to its catalytic effect. In the gasification reaction of semi-coke and CO
2, the cyclic stability of Ca
2Fe
2O
5 catalyst depends on the thermal stability of the catalyst structure. During the cyclic use of the catalyst, the decrease in catalytic activity is mainly attributed to the encapsulation of inorganic ash in the semi-coke fuel. Research on the performance of DC-SOFC shows that when 10% Ca
2Fe
2O
5 catalyst has been added to the semi-coke, the peak power density of the cell increases from 15.3 mW/cm
2 to 23.7 mW/cm
2. The EIS analysis shows that the anode mass transfer resistance is the main factor affecting the output performance and fuel utilization of DC-SOFC. Reducing the mass transfer resistance caused by the accumulation of ash and catalyst can effectively improve the DC-SOFC life and fuel utilization.